VMware VIEW COMPOSER 2.5 - ARCHITECTURE Manuale Utente Scaricare il pdf (Pagina 24)

EMC Infrastructure for Virtual Desktops Enabled by EMC VNX Series,

VMware vSphere 4.1, VMware View 4.5, and VMware View Composer 2.5 Proven Solution Guide

VNX for file network configuration

Data Mover

ports

VNX5300 consists of two Data Movers. These Data Movers can be configured in an

active/active or active/passive configuration. In this solution, the Data Movers

operated in the active/passive mode. In the active/passive configuration, the passive

Data Mover serves as a failover device for the active Data Mover.

The VNX5300 Data Mover was configured for four 1 Gb interfaces on a single SLIC.

Link Aggregation Control Protocol (LACP) was used to configure ports cge-2-0 and

cge-2-1. Ports cge-2-2 and cge-2-3 were left free for further expansion.

The lacp1 device was used to support virtual machine traffic, home folder access,

and external access for roaming profiles.

The external_interface device was used for administrative purposes to move data in

and out of the private network on VLAN 274. Both the interfaces exist on the LACP1

device configured on cge-2-0 and cge-2-1

The ports are configured as follows:

external_interface protocol=IP device=lacp1

inet=10.6.121.55 netmask=255.255.255.0

broadcast=10.6.121.255

UP, Ethernet, mtu=1500, vlan=521,

macaddr=0:60:48:1b:76:92

lacp1_int protocol=IP device=lacp1

inet=192.168.80.5 netmask=255.255.240.0

broadcast=192.168.95.255

UP, Ethernet, mtu=9000, vlan=274,

macaddr=0:60:48:1b:76:92

LACP

configuration

on the Data

Mover

To configure the link aggregation that uses cge-2-0 and cge-2-1 on server_2, type

the following at the command prompt:

$ server_sysconfig server_2 -virtual -name <Device Name> -

create trk –option "device=cge-2-0,cge-2-1 protocol=lacp"

To verify if the ports are channeled correctly, type the following:

$ server_sysconfig server_2 -virtual -info lacp1

server_2:

*** Trunk lacp1: Link is Up ***

*** Trunk lacp1: Timeout is Short ***

*** Trunk lacp1: Statistical Load C is IP ***

Device Local Grp Remote Grp Link LACP Duplex Speed

--------------------------------------------------------------

cge-2-0 10003 5888 Up Up Full 1000 Mbs

cge-2-1 10003 5888 Up Up Full 1000 Mbs

The remote group number must match for both the ports and the LACP status must

be “Up.” Verify if the appropriate speed and duplex are established as expected.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 72 73

Commenti su questo manuale

Nessun commento

VMware VIEW COMPOSER 2.5 - ARCHITECTURE Manuale Utente Pagina 24

Commenti su questo manuale

Prodotti e manuali riguardandi Server VMware VIEW COMPOSER 2.5 - ARCHITECTURE